ALLIANCE AA9231 Service page 47

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
h. Disconnect motor wire harness from base wire
harness at disconnect blocks. Refer to
Figure 23.
NOTE: Starting with serial No. R1339650XG and
continuing through R1566483YG, the motor wire
harness and base wire harness disconnect blocks
are attached to the inside of the left side of the
washer cabinet with double sided tape. If the
disconnect blocks are removed during service, a
new piece of tape will be needed to hold the harness
disconnect blocks to the side of the washer cabinet.
i. If present, remove screw holding ground wire
to washer base. Refer to Figure 19.
j. Remove four screws holding motor and
mounting bracket to washer base, then lift
complete assembly out of washer. Refer to
Figure 19.
NOTE: When reinstalling motor and mounting
bracket, positioning tab on right side of mounting
32283
Cap
Screw
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
Drive
Pulley
Figure 35
bracket must be placed in positioning hole in base.
Mounting bracket must be shifted toward rear of
washer to its limit of travel within the mounting
bracket attaching screws.
k. Remove screw, washer and helix holding drive
pulley to the input shaft of the transmission
assembly. Refer to Figure 35.
l. Remove drive pulley by tilting right side up and
slide pulley out between right front and rear tub
support legs.
IMPORTANT: The two large flat washers must be
in place between the spring and drive pulley when
reassembling. Refer to Figure 36 for assembly
sequence.
NOTE: When reinstalling pulley, place a small
amount of lubricant to the top side of the drive
pulley that will be contacting large flat washers.
Lubricate helix ramps also. Refer to Figure 36.
Section 5 Service Procedures
Helix
Washer
WA054-SV
W003
45