Cabinet Top Assembly - ALLIANCE AA9231 Service

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
Cabinet Top
Wire
Hold-Down
Harness
Screw
Clip
Wire Harness
Disconnect
Blocks
Through Serial No. R1339649XG

35. CABINET TOP ASSEMBLY

a. Remove two screws from bottom edge of front
panel. Refer to Figure 16.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top.
Refer to Figure 16.
c. Remove two cabinet top hold-down screws.
Refer to Figure 23.
d. If area or space permits, tape loading door
closed and lift cabinet top to a vertical position
by hinging it on the rear hold-down bracket.
NOTE: Cabinet top is self-supporting, however, a
small chain may be used for additional support.
Refer to Figure 24.
32
Door Switch
and Out-of-Balance
Switch Assembly
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
Wire Harness
Disconnect
Blocks
Starting Serial No. R1339650XG and
Continuing through R1566483YG
Figure 23
Chain
Cabinet Top
Hold-Down
Screw
Door Switch
and Out-of-Balance
Switch Assembly
Figure 24
W003
32283