Motor And Mounting Bracket - ALLIANCE AA9231 Service

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.

30. MOTOR AND MOUNTING BRACKET

a. Remove front panel. Refer to Paragraph 27.
b. Disconnect motor wire harness from base wire
harness at disconnect blocks. Refer to
Figure 23.
NOTE: Starting with serial No. R1339650XG and
continuing through R1566483YG, the motor wire
harness and base wire harness disconnect blocks
are attached to the inside of the left side of the
washer cabinet with double sided tape. If the
disconnect blocks are removed during service, a
new piece of tape will be needed to hold the harness
disconnect blocks to the side of the washer cabinet.
c. Remove pump belt. Refer to Paragraph 28.
Then remove drive belt. Refer to Paragraph 29.
NOTE: When installing belts, adjust pump belt.
Refer to Paragraph 51. There is no drive belt
adjustment.
d. If present, remove screw holding ground wire
to washer base.
28
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
e. Remove four screws holding motor and
mounting bracket to washer base. Refer to
Figure 19. Then lift complete assembly out of
washer.
NOTE: When installing motor and mounting
bracket, tab on right bottom flange of mounting
bracket must be placed in position hole in base.
Mounting bracket must be shifted toward rear of
washer to its limit of travel within the mounting
bracket attaching screws.
f. Remove nuts, steel washers, spacers and rubber
mounts holding motor to mounting bracket.
Refer to Figure 20. Lift motor off mounting
bracket and remove balance of rubber mounts
and steel washers from motor mounting studs.
IMPORTANT: When installing motor on mounting
bracket, position motor with switch facing toward
left side of mounting bracket.
NOTE: Refer to Figure 20 for motor and mounting
bracket assembly sequence.
W003
32283