Brake Assembly - ALLIANCE AA9231 Service

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
Brake
Pad
Rubber
Sleeve
Shoulder
Screw
Brake
Assembly
(Starting
Serial No.
R1438802XN)

42. BRAKE ASSEMBLY

a. Remove drive pulley and helix. Refer to
Paragraph 41.
b. Using a right angle needle nose pliers, remove
spring from around lower transmission tube
(located inside the brake assembly). Refer to
Figure 36.
NOTE: Remove spring by turning in a
COUNTERCLOCKWISE direction (looking from
lower end of input shaft of transmission assembly).
46
Lower
Bearing
Housing
Brake
Assembly
Flat
(Through
Washers
Serial No.
R1438801XN)
Drive
Pulley
Helix
Washer
Cap
Screw
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
Bearing
Spacer
Apply
Lubricant
Here
Spring
Apply
Lubricant
Here
Figure 36
c. Remove three screws holding brake pads,
rubber sleeves and brake assembly to lower
bearing housing, then remove brake assembly,
pads and spacer off bottom of transmission
assembly. Refer to Figure 36.
IMPORTANT: When reinstalling brake assembly,
we recommend replacing the three brake pads. DO
NOT replace just the worn pads. Apply a small
amount of No. 26594P Silicone Lubricant to both
sides of each brake pad where it will contact the
brake assembly.
NOTE: Refer to Figure 36 for assembly sequence.
Support
Leg
Pivot
Dome
W443P
Base
Assembly
W003
32283