No Agitation; Constant Agitation - ALLIANCE AA9231 Service

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.

6. NO AGITATION

POSSIBLE CAUSE
*Inoperative timer. Timer is designed to pause
(SOAK) during the DELICATE cycle.
Inoperative motor.
Inoperative pressure switch.
Broken, loose or incorrect wiring.
Loose or broken drive belt.
Inoperative transmission assembly.
Sheared motor pulley roll pin.
Drive motor overload protector has cycled.
Bind in pump.
Loading door is open or door switch is inoperative. • Close door or test switch and replace if inoperative.
†Inoperative electronic control.

7. CONSTANT AGITATION

POSSIBLE CAUSE
*Inoperative timer.
Inoperative drive motor.
Shorted or incorrect wiring.
Inoperative transmission assembly.
†Inoperative electronic control.
* Mechanical Timer Models only
† Electronic Control Models only
32283 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
TO CORRECT
• Test timer and replace if inoperative.
• Test motor and replace if inoperative.
• Test switch and replace if inoperative.
• Refer to appropriate wiring diagram.
• Adjust or replace belt.
• Repair or replace transmission assembly.
• Remove drive motor and replace roll pin and any other
damaged parts.
• Refer to Paragraph 10.
• Replace pump.
• Refer to Section 8 to check out the electronic control
operation.
TO CORRECT
• Test timer and replace if inoperative.
• Test motor and replace if inoperative.
• Refer to appropriate wiring diagram.
• Repair or replace transmission assembly.
• Refer to Section 8 to check out the electronic control
operation.
Section 3 Troubleshooting
W003
9