ALLIANCE AA9231 Service page 74

Section 8 Service Procedures Unique to the Electronic Control Model Washers
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
EXTRA An extra rinse can be obtained by
RINSE pressing the EXTRA RINSE pad. If
a warm rinse has been selected, both
rinses will be warm. An extra rinse
is not available in the SOAK cycle.
NOTE: When EXTRA RINSE is
selected, the final spin of the
NORMAL cycle will be three
minutes. After the three-minute
spin, a deep rinse will begin,
followed by the normal final spin
time for the cycle selected. Refer to
the Cycle Sequence chart for total
cycle times. Refer to Figure 53.
SIGNAL A signal is provided to let you know
when the cycle has been completed.
The signal has three distinctive tone
levels. Pressing the SIGNAL pad
once will produce the softest tone.
Press the pad again and the tone will
get louder. Pressing the pad a third
time will result in setting the loudest
tone. To turn the signal off, press the
pad repeatedly until the SIGNAL
light goes off. The signal will not
sound if the light is off.
72
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
MEMORY
SAVE
You can create and save your
favorite cycles by using the
MEMORY SAVE option. Each
programmed cycle—REGULAR,
PERM PRESS, DELICATES,
KNITS and SOAK can have one
memory cycle for a total of five
memory or favorite cycles in
addition to the preprogrammed
cycles.
To save a favorite cycle, first select a
program cycle, then customize that
cycle. When all selections have been
made, press the MEMORY SAVE
pad. Your favorite cycle is now
saved. This cycle will be stored until
you either change the cycle or until
there is a power outage of several
seconds or longer. Your customized
cycle can be recalled from memory
by pressing the appropriate
ON/SELECT pad for the cycle
twice in succession.
The light on the MEMORY SAVE
pad will light up when the memory
cycle is on.
To change a memory cycle, press
the programmed cycle selection pad
twice to recall the memory cycle.
Change the cycle, then press the
MEMORY SAVE pad. The old
memory cycle will be deleted and
the new cycle will be memorized in
its place.
NOTE: The SIGNAL and
DELAYED START cannot be
saved in memory.
W003
32283