Door And Out-Of-Balance Switch And Bracket Assembly - ALLIANCE AA9231 Service

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
36. DOOR AND OUT-OF-BALANCE SWITCH
AND BRACKET ASSEMBLY
Refer to Figure 25.
NOTE: Starting with Serial No. R1339650XG and
continuing through R1566483YG, a guard was
added to the lid switch and bracket assembly,
Figure 25. If the lid switch and bracket assembly are
removed for service and the guard is removed, the
guard MUST be reinstalled on the lid switch and
bracket assembly to reduce the risk of an electric
shock.
(starting Serial No.
continuing through
34
Shield
Lever
Lid Switch
Guard
R1339650XG and
R1566483YG)
Attaching
Screw
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
a. Hinge cabinet top or remove. Refer to
Paragraph 35.
b. Remove screw holding switch and bracket
assembly to underside of the right front corner
flange of the cabinet top.
c. Disconnect wires from switch.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
d. Remove two screws holding switch to bracket.
NOTE: After installing switch and bracket
assembly, adjust per Paragraph 52.
Switch
Attaching
Screw
Spring
Attaching
Screws
Figure 25
Switch
Bracket
Cabinet
Top
W438P
W003
32283