Water Supply Requirements; Water Temperature; Water Pressure - ALLIANCE SWF-Series Installation & Operation Manual

Frontload washer
Table of Contents

Advertisement

Water Supply Requirements

WARNING
Under certain conditions, hydrogen gas
may be produced in a hot water system
that has not been used for two weeks or
more. HYDROGEN GAS IS EXPLOSIVE. If
the hot water system has not been used
for such a period and before using the
washer, turn on all hot water faucets and
let the water flow from each for several
minutes. This will release any
accumulated hydrogen gas. The gas is
flammable. Do not smoke or use an open
flame during this time.
NOTE: Water supply faucets must fit standard
3/4 inch (19.1 mm) female garden hose couplings.
DO NOT USE SLIP-ON OR CLAMP-ON
CONNECTIONS.
NOTE: Water supply faucets should be readily
accessible to permit turning them off when washer
is not being used.

Water Temperature

Cold:
Recommended cold water temperature is 60° to 80°
Fahrenheit (16° to 27° Celsius).
Hot:
Recommended hot water temperature is 120° to 140°
Fahrenheit (49° to 60° Celsius).
Warm:
Mixture of hot and cold water. (Warm water
temperature is dependent upon the water temperature
and the pressure of both the hot and cold water supply
lines.)
IMPORTANT: Turn off water supply faucets after
check-out and demonstration. Owner should turn
off water supply whenever there will be an
extended period of non-use.
801479
W029
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
NOTE: Longer fill hoses are available (as optional
equipment at extra cost) if the hoses supplied with
the washer are not long enough for the installation.
Order hoses as follows:
No. 20617 Fill Hose (8 feet) (2.44 m)
No. 20618 Fill Hose (10 feet) (3.05 m)
1
4
1
Water Supply Faucets
2
Hot Water Connection
3
Cold Water Connection
4
Fill Hoses
Figure 17

Water Pressure

Pressure must be a minimum of 20 to a maximum of
120 pounds per square inch (138 to 827 kPa) static
pressure measured at the faucet.
NOTE: Water pressure under 20 pounds per
square inch (138 kPa) will cause an extended fill
time in the washer and may not properly flush out
the detergent dispenser.
Installation
2
3
WATER
MIXING
VALVE
FLW1974N
FLW1974N
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Swr-series

Table of Contents