Pump Belt; Drive Belt - ALLIANCE AA9231 Service

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.

28. PUMP BELT

a. Remove two screws from bottom edge of front
panel. Refer to Figure 16.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top.
Refer to Figure 16.
c. Loosen two front mounting screws and one rear
mounting screw holding pump and bracket to
washer base. Refer to Figure 17. Pivot entire
assembly toward motor to loosen belt tension.
d. Run belt off motor pulley, then remove belt
from pump pulley.
NOTE: After installing pump belt, adjust belt.
Refer to Paragraph 51.

29. DRIVE BELT

a. Remove two screws from bottom edge of front
panel. Refer to Figure 16.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top.
Refer to Figure 16.
c. Loosen two front mounting screws and one rear
mounting screw holding pump and bracket to
washer base. Refer to Figure 17. Pivot entire
assembly toward motor to loosen belt tension.
26
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
Pump
Belt
d. Run belt off motor pulley, then remove belt
from pump pulley.
NOTE: After installing pump belt, adjust belt.
Refer to Paragraph 51.
e. Reach in through front of motor mount and
move idler lever to the left to release tension on
belt.
IMPORTANT: Use care when releasing the idler
lever tension. If the idler spring or helper spring is
overstretched, washer operation will be affected.
f. While holding idler lever, reach in and around
right side of motor and run belt off right side of
large drive pulley. Refer to Figure 18.
g. Remove belt from motor pulley and pull belt
out through front of motor mount.
IMPORTANT: Drive belt MUST be replaced with
belt No. 28808 (special clutch-type belt) for proper
washer operation.
Pump
Attaching
Screws
Figure 17
W003
32283