ALLIANCE AA9231 Service page 41

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
Water
Press Here
to Assemble
Garter
Spring
Apply Bead of No.
27615P Sealant
Here (Step "e")
TO INSTALL NO. 495P3 HUB AND SEAL
KIT
IMPORTANT: Be sure inner surface of tub flange is
clean of all foreign material before installing new
seal.
a. Apply a small amount of 27615P Sealant,
(supplied in kit) around outer surface of tub
flange. Refer to Figure 31.
IMPORTANT: DO NOT allow sealant to get in
contact with the flinger, because this could prevent
flinger from keeping moisture out of upper bearing.
Refer to Figure 31.
b. Apply a light film of nonstaining petroleum
jelly (such as Vaseline
water seal and to outer surface of stainless steel
sleeve. Refer to Figure 32.
IMPORTANT: DO NOT over lubricate!
c. Insert stainless steel sleeve into water seal from
bottom side of the seal until the sleeve is flush
with bronze portion of the seal. Refer to
Figure 32.
32283
Lubricate
(Lubricate per
Seal
Step "b")
®
) to bronze portion of
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
Stainless Lubricate
Steel
(Lubricate per
Sleeve Step "b")
Insert Sleeve from
Bottom Side of Seal
Figure 32
d. Leave the garter spring on seal. Place new seal
over outer tub flange (with seal lip on outside of
tub flange). Then press seal into tub flange
opening using moderate finger pressure.
e. Carefully apply a small amount of No. 27615P
Sealant (supplied with kit) around outer edge of
seal and tub (area located just below garter
spring). Refer to Figure 32.
IMPORTANT: DO NOT allow sealant to contact
sealing surface of water seal because it will cause a
water leak.
f. Lubricate inner splines of new hub assembly
(supplied in kit) with No. 27604P Anti-Seize
Compound.
g. Carefully place new hub assembly on splined
transmission tube.
IMPORTANT: Firmly push hub down against outer
tub seal and hold in this position.
h. While holding hub down, place spline insert
onto the transmission tube until it bottoms
against the hub. Then place the hex nut on the
transmission tube (with the larger inside bevel
on the nut toward the spline insert). Tighten the
Section 5 Service Procedures
Bronze Portion
of Seal
Flush
Garter
Spring
Apply Bead of No.
27615P Sealant
Here (Step "e")
W003
39