ALLIANCE AA9231 Service page 40

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
g. Remove four screws holding washtub to hub.
Refer to Figure 28. Then lift washtub out of
outer tub.
IMPORTANT: When removing washtub, DO NOT
lift up on lint filter as you could damage it. Grasp
top flange of washtub and remove from outer tub.
NOTE: Be sure all traces of old gasket are removed
from bottom of washtub.
h. Remove agitator drive bell. Refer to Paragraph
26.
i. Remove the seal head from the hub.
IMPORTANT: We recommend that both the seal
seat and the seal head be replaced together in pairs.
DO NOT replace only one of the two seals.
j. Remove large hex nut using a No. 306P4 Hex
Wrench. Refer to Figure 30.
k. Remove spline insert from transmission tube.
38
Outer Tub
Flange
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
Apply
Bead of
No. 27615P
Sealant
(Step "a")
Figure 31
IMPORTANT: Use a new spline insert each time
hex nut is removed. DO NOT reuse old insert
because hex nut may loosen during washer
operation.
l. Remove hub from splines on transmission tube.
NOTE: It may be necessary to use a gear puller to
remove hub.
m. Remove old water seal from outer tub.
IMPORTANT: Use care when removing old seal so
as not to damage tub flange or porcelain.
Flinger
W003
32283