Water Seal And Hub Assembly - ALLIANCE AA9231 Service

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
TO REMOVE LINT FILTER FROM
WASHTUB
a. Place a small screwdriver in behind the slots
provided in the lint filter. Refer to Figure 29.
b. Carefully pry the pins of the lint filter out of the
holes in the washtub. Refer to Figure 29.
Pins
Figure 29
NOTE: As you are prying out the pins, lift up on the
filter.
c. Pry the filter pins out of the washtub holes
approximately half way around the tub before
the filter can be removed.
TO INSTALL LINT FILTER IN WASHTUB
Place the lint filter on top of washtub, making sure
the filter pins line up with the holes in the
washtub. Then carefully push the filter down into
the washtub until all the pins snap into their
respective holes.
32283
Slots
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING

39. WATER SEAL AND HUB ASSEMBLY

IMPORTANT: If water is present in washtub, spin
and pump out before removing drive bell.
a. Remove two screws from bottom edge of front
panel. Refer to Figure 16.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top.
Refer to Figure 16.
c. Remove two cabinet top hold-down screws.
Refer to Figure 23.
d. Remove agitator. Refer to Paragraph 25.
e. Disconnect filler hose from backflow
preventer. Then remove the eight clips holding
cover to outer tub. Refer to Figure 27.
NOTE: When reinstalling filler hose, white line on
hose must be aligned with center line of backflow
preventer. Refer to Figure 26. A 1/8 inch clearance
is necessary to prevent the hose from rubbing on the
flange of the tub cover. Refer to Figure 27. Loosen
hose clamp and move hose to obtain the proper
clearance.
f. Lift cover off outer tub and set beside washer
cabinet. Remove old cover gasket.
Transmission
Output Shaft
Hub
Assembly
Section 5 Service Procedures
Hex
Nut
Figure 30
W003
37