ALLIANCE AA9231 Service page 29

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
TO INSTALL NO. 28808 DRIVE BELT
NOTE: If the new belt is replacing a burned belt,
the motor pulley "V" groove must be polished with
a fine (320 grit) emery cloth to remove the rubber
residue. The residue will affect the washer spin
operation.
a. Push belt in through front of motor mount and
place belt on motor pulley.
b. Reach in and around right side of motor,
starting with belt on right side of large drive
pulley, run belt onto pulley.
c. Reach in through front of motor mount and
move idler lever to the left.
Wire harness
must be installed
ahead of spring.
Helper
Spring
32283
Idler
Spring
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
IMPORTANT: Use care when releasing the idler
lever tension. If the idler spring or helper spring is
overstretched, washer operation will be affected.
d. While holding idler lever, reach around right
side of motor and place belt on idler pulley.
IDLER PULLEY MUST RIDE ON OUTSIDE
OF BELT.
NOTE: There is no belt adjustment after installing
new drive belt. Check to be sure motor and
mounting bracket have been shifted toward rear of
washer to its limit of travel within the mounting
bracket attaching screws. If the motor and
mounting bracket must be repositioned, loosen the
four motor attaching screws and shift motor and
mounting bracket toward rear of washer to its limit
of travel. Retighten the four attaching screws. Refer
to Figure 18.
Figure 18
Section 5 Service Procedures
Drive
Pulley
Drive
Belt
Motor
Attaching
Screws
W003
27