ALLIANCE AA9231 Service page 35

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
TO REMOVE CABINET TOP FROM
WASHER
a. Repeat steps "a", "b" and "c" of Paragraph 35.
b. Remove six screws (3 on top and 3 at lower
front) holding control hood assembly to control
hood rear panel and cabinet top. Disconnect
hose from pressure switch and push hose down
through hole in cabinet top. Reinstall control
hood assembly.
c. Disconnect wire harness at disconnect blocks.
Refer to Figure 23.
NOTE: Starting with serial No. R1339650XG and
continuing through R1566483YG, the motor wire
harness and base wire harness disconnect blocks
are attached to the inside of the left side of the
washer cabinet with double sided tape. If the
disconnect blocks are removed during service, a
new piece of tape will be needed to hold the harness
disconnect blocks to the side of the washer cabinet.
d. Through Serial No. R1339649XG, remove wire
clips holding wire harness and pressure hose to
top flange of left side of washer cabinet. Refer
to Figure 23.
e. Tape loading door closed.
f. Lift front of cabinet top slightly and pull
forward to disengage from rear hold-down
brackets.
32283 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
g. Pull top forward far enough to permit
disconnecting green ground wires from top rear
corner of washer cabinet. Disconnect wires
from mixing valve solenoids at rear of washer.
NOTE: Starting with Serial No. R1339650XG and
continuing through R1566483YG, a guard was
added to the mixing valve area. Refer to Figure 3.
This guard must be removed before disconnecting
the wires from the mixing valve solenoids.
NOTE: Refer to appropriate wiring diagram when
rewiring mixing valve solenoids.
h. Carefully lift cabinet top off washer and set
alongside the washer cabinet on protective
padding.
To reduce the risk of personal injury, be
careful not to damage door switch and out-
of-balance switch lever when removing the
cabinet top.
Section 5 Service Procedures
WARNING
W003
33