Belt - ALLIANCE HWF561*E1102 Service

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.

51. BELT

a. Unlock control panel. Refer to Figure 17, Step
1.
b. Pull top of control panel away from control
cabinet far enough to allow lifting control panel
up and off the rail support of the control
cabinet. Refer to Figure 17, Step 2.
c. Remove control panel away from control
cabinet as far as wires permit. Refer to
Figure 17, Step 3.
d. Remove two screws holding front of cabinet
top to top front edge of control cabinet front.
Refer to Figure 19.
e. If area or space permits, lift cabinet top to a
vertical position by hinging it on the rear
hinges.
NOTE: To avoid damage to hinges, be sure to
support cabinet top with a small chain or something
similar. Refer to Figure 21.
f. Run belt off cylinder pulley while slowly
turning pulley. Refer to Figure 28.
g. Remove belt from motor shaft.
NOTE: When installing belt, adjust belt tension per
Paragraph 65.
800168 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
3
1
2
Section 5 Service Procedures
BELT
ACCESS
FROM
ABOVE
CYLINDER
PULLEY REAR
ACCESS
PANEL
BELT
ACCESS
FROM
BELOW
MOTOR
H113SE1B
Figure 28
W003
97