Fns Adjustment Of The Position Of Paper Exit Arm - Konica Minolta 8050 Service Manual

OTHER ADJUSTMENTS
9.10 FNS adjustment of the posi-
tion of paper exit arm
A. Procedure
1. Open the finisher door and pull out the stacker
unit.
2. Check whether the upper face of the paper exit
belt arm [4] is located at the center of 2 marks
[5] when the edge of the actuator [2] for the belt
detection gear [1] is placed in the notched hole
[3] at the rear panel.
If not, perform the adjustment.
3. Remove the rail stopper screws for the stacker
unit. Then, pull out the stacker unit further.
Note:
• To avoid the finisher from falling, make sure
to place a support under the stacker unit.
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
[1]
[4]
1-152
[3]
[2]
[5]
8050fs1087