Table of Contents
Advertisement
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
8. Rotate the stapler gear [1] in the lower direction
and adjust the clincher position so that the 2
pins [2] of the stapler positioning jig get
smoothly into the positioning holes [4] of the
clincher [3]. And then rotate the gear [1] in the
lower direction to set the pin securely into the
positioning hole.
Note:
• When fitting forcibly the pin of the stapler
positioning jig, this may result in the pin
being hard to draw out. Be sure to rotate the
stapler gear with care.
9. Tighten up each of 4 clincher fixing screws.
10. Rotate the stapler gear in the upper direction to
remove the jig.
11. Bring the cartridge back to the original position.
12. Check the stapling operations.
[1]
[2]
1-163
OTHER ADJUSTMENTS
[3]
[4]
8050fs1126
2
Advertisement
Table of Contents
