Table of Contents
Advertisement
2.
CHECKPOINTS WHEN PERFORMING ON-SITE SERVICE
Konica Minolta brand copiers are extensively tested before shipping, to ensure that all applicable safety standards are met,
in order to protect the customer and customer engineer (hereafter called the CE) from the risk of injury. However, in daily
use, any electrical equipment may be subject to parts wear and eventual failure. In order to maintain safety and reliability,
the CE must perform regular safety checks.
2.1 Power Supply
Connection to Power Supply
• Check that mains voltage is as specified. Plug the power cord into the dedi-
cated wall outlet with a capacity greater than the maximum power consump-
tion.
If excessive current flows in the wall outlet, fire may result.
• If two or more power cords can be plugged into the wall outlet, the total load
must not exceed the rating of the wall outlet.
If excessive current flows in the wall outlet, fire may result.
• Connect power plug directly into wall outlet having same configuration as the
plug.
Use of an adapter leads to the product connecting to inadequate power
supply (voltage, current capacity, grounding), and may result in fire or elec-
tric shock.
If proper wall outlet is not available, advice the customer to contact quali-
fied electrician for the installation.
• Make sure the power cord is plugged in the wall outlet securely.
Contact problems may lead to increased resistance, overheating, and the
risk of fire.
Ground Lead
• Check whether the copier is grounded properly.
If current leakage occurs in an ungrounded copier, you may suffer electric
shock while operating the copier. Connect the ground lead to one of the
following points:
a. Ground terminal of wall outlet
b. Ground terminal for which Class D work has been done
SAFETY AND IMPORTANT WARNING ITEMS
WARNING
WARNING
S-3
kw
2
Advertisement
Table of Contents
