OTHER ADJUSTMENTS
9.20 TU adjustment of the sheet
cutting parallelism
A. Procedure
1. Measure the length between the folding face [1]
and trimming surface [2] and calculate the paral-
lelism. Then, check whether it is within the stan-
dard value.
Standard value: parallelism = A-B = ± 1 mm or
less
If not, perform the following adjustment.
2. Open the front door [1].
3. Push up the pressure release lever [2].
4. Loosen the screw [3]. Then adjust the convey-
ance guide plate [5] based on the mark [4].
5. Tighten the screw [3].
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
[1]
[1]
[4]
1-178
A
B
8050fs1117
[2]
[5]
[3]
8050fs1118
[2]