Table of Contents
Advertisement
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
5. "Lead edge timing (Tray 1) screen"
For the printer lead edge timing adjustment,
the following items are provided. Press the
[NEXT ADJUSTMENT] key or [PREVIOUS
ADJUSTMENT] key to select an item you want
to adjust.
• "Lead edge timing (Tray 1)"
• "Lead edge timing (Tray 2)"
• "Lead edge timing (Tray 3)"
• "Lead edge timing (Bypass)"
• "Lead edge timing (Tray 4)"
• "Lead edge timing (ADU)"
• "Tray large size normal paper offset"
• "Tray large size thick paper offset"
• "Tray small size normal paper offset"
• "Tray small size thick paper offset"
• "Bypass large size normal paper offset"
• "Bypass large size thick paper offset"
• "Bypass small size normal paper offset"
• "Bypass small size thick paper offset"
• "Large size normal paper offset (ADU)"
• "Large size thick paper offset (ADU)"
• "Small size normal paper offset (ADU)"
• "Small size thick paper offset (ADU)"
Note:
• Large size: 300 mm or more in length in the
paper feed direction
• Small size: 300 mm or less in length in the
paper feed direction
• Thick Paper: 106 g/m
6. Enter a numeric value through the numeric
keys and press the [SET] key.
7. Press the [COPY SCREEN] key.
8. Set the copy setting according to the item
adjusted and press the START button to output
a test pattern (No. 16).
2
or more
1-69
9. Measure the lead edge timing with a scale.
• Standard value: 20 mm ± 0.5 mm
10. When the value is not within the standard,
press the C button while pressing the P button.
11. "Printer lead edge timing screen"
Enter a numeric value through the numeric
keys and press the [SET] key.
• Setting range: -60 to +60, 1 step = 0.1 mm
12. Repeat steps 6 to 10 until the standard value is
obtained.
13. Press the [PREVIOUS SCREEN] key to return
to the "Timing adjustment mode menu screen."
(2) Printer registration loop adjustment
Adjust the paper loop amount in the registration
roller section to remove paper skew and wrinkle, or
paper jamming in the registration section.
This adjustment can be shown in the key operator
mode by setting the DIPSW12-1 to 1.
a.
Procedure
1. Enter the 36 mode.
2. "36 mode menu screen"
Press the [2. Image adjustment] key.
3. "Image adjustment menu screen"
Press the [2. Timing adjustment] key.
4. "Timing adjustment mode menu screen"
Press the [2. Printer registration loop adj.] key.
36 MODE
8050fs1010
1
Advertisement
Table of Contents
