Table of Contents
Advertisement
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
10. "Printer pre-registration adj. screen"
Enter a numeric value through the numeric
keys and press the [SET] key.
• Setting range: -99 (large) to +99 (small),
1 step = 0.1 mm
11. Repeat steps 6 to 10 until the standard value is obtained.
12. Press the [PREVIOUS SCREEN] key to return
to the "Timing adjustment mode menu screen."
(4) Printer erasure amount adjustment
Conduct an erasure amount adjustment.
This adjustment can be shown in the key operator
mode by setting the DIPSW12-1 to 1.
a.
Procedure
1. Enter the 36 mode.
2. "36 mode menu screen"
Press the [2. Image adjustment] key.
3. "Image adjustment menu screen"
Press the [2. Timing adjustment] key.
4. "Timing adjustment mode menu screen"
Press the [4. Printer erasure amount adj.] key.
5. "Printer erasure amount adjustment screen"
Press the [COPY SCREEN] key.
6. Select the A3 or 11 x 17 paper and press the START
button with a test chart set to the original glass.
7. Check the printer erasure amount.
• Standard value: 3 mm or less
8. When the value is not within the standard,
press the C button while pressing the P button.
9. "Printer erasure amount adjustment screen"
Enter a numeric value through the numeric
keys and press the [SET] key.
• Setting range: -20 to +40, 1 step = 0.1 mm
10. Repeat steps 6 to 9 until the standard value is obtained.
11. Press the [PREVIOUS SCREEN] key to return
to the "Timing adjustment mode menu screen."
(5) Scanner re-start timing adjustment
Adjust re-start timing of original scanning.
In this adjustment, the starting position for reading
while in the original scanning mode is adjusted.
This adjustment can be shown in the key operator
mode by setting the DIPSW12-1 to 1.
Note:
• Make sure that the printer timing adjustment
has been completed.
a.
Procedure
1. Enter the 36 mode.
2. "36 mode menu screen"
Press the [2. Image adjustment] key.
3. "Image adjustment menu screen"
Press the [2. Timing adjustment] key.
4. "Timing adjustment mode menu screen"
Press the [5. Scanner re-start timing adj.] key.
5. "Scanner re-start timing adjustment screen"
Press the [COPY SCREEN] key.
6. Select the A3 or 11 x 17 paper and press the
START button with a test chart set to the origi-
nal glass.
7. Check the scanner re-start timing.
• Standard value: 3 mm or less
8. When the value is not within the standard,
press the C button while pressing the P button.
9. "Scanner re-start timing adjustment screen"
Enter a numeric value through the numeric
keys and press the [SET] key.
• Setting range: -10 to +20, 1 step = 0.1 mm
10. Repeat steps 6 to 9 until the standard value is
obtained.
11. Press the [PREVIOUS SCREEN] key to return
to the "Timing adjustment mode menu screen."
1-71
36 MODE
2
Advertisement
Table of Contents
