Table of Contents
Advertisement
OTHER ADJUSTMENTS
C. Procedure (Old type)
Note:
• Never move the stapler unit in a horizontal
direction manually (it may cause the teeth to
skip between the belt and gear).
1. Perform a stapling operation to check for the
clinch failure.
• Buckled staple-needles [1]
• Floating stapling [2] (standard value: L = 1 mm or
less)
• Height of belt staple-needle [3] (standard value:
L = 0.7 mm or less)
If there is a failure, perform the following adjust-
ment.
Note:
• Adjust the clincher or stapler if it is replaced
or removed.
2. Open the finisher door and pull out the stacker
unit.
3. Remove the rail stopper screws for the stacker
unit. Then, pull out the stacker unit further.
Note:
• To avoid the finisher from falling, make sure
to place a support under the stacker unit.
4. Remove the stapler unit cover.
5. Remove the cartridge [1], open the cover [2],
and then remove the staple sheet [3] by sliding
it.
2
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
[1]
[2]
[3]
1-164
L=1mm
L=0.7mm
8050fs1097
[1]
[2]
8050fs1098
[3]
Advertisement
Table of Contents
