Table of Contents
Advertisement
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
3. Loosen a screw [1] and adjust the position of the
tray upper limit sensor/BP (PS25) [2].
Note:
• Take note of the original scale.
(1) If it is not within the standard value:
Adjust the vertical position of the sensor mounting
bracket to make the height of the entrance guide
upper surface and the up/down plate upper surface
to be within the standard value.
• When raising the height of the up/down plate:
lower the sensor mounting bracket.
• When lowering height of the up/down plate:
lower the sensor mounting bracket.
(2) If any problem occurs:
• When the edge of the fed paper is folded: raise
the position of the sensor mounting bracket.
• When paper with a concave curl is fed: raise the
position of the sensor mounting bracket.
• When paper with a convex curl is fed: lower the
position of the sensor mounting bracket.
1. Replace the paper feed solenoid cover.
2. Replace the ADU.
3. Perform the copy to check the paper feed oper-
ation.
4. Repeat steps 1 to 6 to adjust the position of
PS25 again if the problem continues to occur.
1-141
OTHER ADJUSTMENTS
[2]
[1]
8050fs1052
Advertisement
Table of Contents
