Table of Contents
Advertisement
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
Classifi-
Jam
cation
code
FS
J72-19
J72-20
J72-21
J72-22
J72-23
J72-24
J72-25
J72-26
J72-28
J72-29
J72-30
Causes
After the stacker inlet motor (M713) is
turned ON, stacker inlet sensor
(PS705) is not turned ON within the
specified time.
After paper exit operation is started,
main tray paper exit sensor (PS706) is
not turned ON within the specified time
(when stapling).
After the main tray paper exit sensor
(PS706) is turned ON, it is not turned
OFF within the specified time (in the
large-size staple mode).
After the FNS inlet sensor (PS704) is
turned ON, sub-tray paper exit sensor
(PS701) is not turned ON within the
specified time within the specified time
(in the sub-tray paper exit mode).
After the sub-tray paper exit sensor
(PS701) is turned ON, it is not turned
OFF within the specified time (in the
large-size staple mode).
After completion of stapling, folding
passage sensor (PS726) is not turned
ON.
After the folding knife motor (M719) is
turned ON, folding paper exit sensor
(PS725) is not turned ON within the
specified time.
After the folding paper exit sensor
(PS725) is turned ON, it is not turned
OFF within the specified time.
After the stacker inlet sensor (PW705)
is turned ON, it is not turned OFF within
the specified time.
After the main tray paper exit sensor
(PS706) is turned ON, it is not turned
OFF within the specified time (in the
non-staple mode).
After the main tray paper exit sensor
(PS706) is turned ON, it is not turned
OFF within the specified time (in the
small-size staple mode).
Resulting
operation
FNS/main body
stop immedi-
ately.
4-7
JAM CODE LIST
Correction
Remove jammed paper
in the FNS/main body,
if any.
2
Advertisement
Table of Contents
