OTHER ADJUSTMENTS
9.19 FNS adjustment of the sta-
pler drive belt position
A. Procedure
Note:
• This adjustment is performed only if the posi-
tion between the drive belt and the gear is dis-
placed during another adjustment by mistake.
1. Open the finisher door and pull out the stacker
unit.
2. Remove the rail stopper screws for the stacker
unit. Then, pull out the stacker unit further.
Note:
• To avoid the finisher from falling, make sure
to place a support under the stacker unit.
3. Remove the following parts.
• Rear cover
• Stapler unit cover
4. Insert the stacker unit.
5. Loosen 2 screws (M3) [2] for the staple slide
pulley /B [1] from the rear side with the hexago-
nal wrench [3].
6. Move the stapler and clincher simultaneously
toward center until they contacts with the bear-
ing.
Note:
• Make sure to move them simultaneously. The
flat-stapling stopper may be damaged at the
metal frame of the stapler if they are moved
individually.
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
[2]
1-174
[1]
[3]
8050fs1112