Table of Contents
Advertisement
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
9.18 FNS adjustment of the three-
holding position (only for
FS-215/FN-9/FS-606)
A. Procedure
1. Check whether "adjustment of the angle of the
folding stopper" has been completed.
Folding
Standard value
position
A4R
a
95 mm
b
101 mm
c
101 mm
2. Perform a three-folding operation to check
whether the three-folding position is within the
specification.
If it is not within the specification, perform the
following adjustment.
3. Turn on the main body, adjust the first folding
position (standard value a) in "Finisher adjust-
ment" ⇒ "Three-holding position adjustment" in
the 36 mode. Then, perform the three-folding for
confirmation.
4. Once the first folding line is adjusted within the
specification, open the finisher door and pull out
the stacker unit.
5. Open the three-folding guide plate [1], loosen 2
three-folding stopper screws [2], and then adjust
the position of the three-folding stopper [4]
based on the mark [3].
6. Tighten the 2 screws [2], then perform the three-
folding to check whether the three-folding posi-
tion is within the standard value.
Specification
8.5 x 11R
89.4 mm
± 2 mm
95 mm
± 2 mm
95 mm
± 2 mm
1-173
OTHER ADJUSTMENTS
c
a
b
[2]
[4]
8050fs1110
[3]
[1]
[2]
8050fs1111
2
Advertisement
Table of Contents
