Table of Contents
Advertisement
OTHER ADJUSTMENTS
9.6
FNS
adjustment
bypass conveyance guide
plate magnet
A. Procedure
1. Open the finisher door.
2. Check whether the stopper piece [4] of the
bypass conveyance guide plate is in contact
with the bypass conveyance guide plate /L [5]
when the magnet [2] for the bypass conveyance
guide plate [1] is attached to the front panel [3].
If not, perform the following adjustment.
3. Loosen the magnet screw [1].
4. Push the bypass conveyance guide plate [2]
toward the arrow until the stopper piece [4]
comes into contact with the conveyance guide
plate /L [4].
5. Attach the magnet [5] to the front panel [6].
Then, tighten the magnet screw [1].
6. Close the finisher door.
KONICA MINOLTA 8050/CF5001/C500/8150 Field Service Ver.3.0 Dec. 2004
of
the
[2]
[4]
[1]
1-146
[1]
[5]
[1]
[5]
[2]
[4]
[2]
[6]
[5]
[3]
[3]
8050fs1075
[4]
8050fs1076
Advertisement
Table of Contents
