3. Loosen the vertical-slant adjusting tab screw and move the tab left and right to adjust the head vertical
angle.
7.9 Cutter Holder Height Adjustment
This section describes the procedure to adjust the cutter holder height.
7.9.1
Jigs and Tools
The following jigs and tools are required for cutter holder height adjustment.
•
Cutter holder jig (VJ): JD-42804
TIP
"10.3 Jigs and Tools" p.10-3
7.9.2
Adjustment Procedure
NOTE
Before starting adjustment, remove the following parts.
• Cable cover L
To make adjustment, follow the steps below.
AP-74109 Rev 1.1
"4.6.1 Replacing Print Head" p.4-61
7-40
ValueJet 1304 Service manual
No.
Part name
Vertical-slant adjusting tab
1
Vertical-slant adjusting tab
2
screw