MUTOH ValueJet Service Manual page 110

9. While rotating the damper fixing material, remove the eight ink tubes from the damper fixing material
hook.
1
2
10. Remove the damper fixing material.
11. Remove the eight damper assemblies connected to the print head that needs to be replaced, with a flat-
head driver.
CAUTION
• Do not press the transparent film on the damper assembly with your hand. Doing so may
discharge the ink filled inside the damper assembly.
• Be careful not to damage the transparent film on the damper assembly.
NOTE
When removing the damper assembly, note the following.
• To easily remove the damper assembly, insert a flat-head driver between the carriage and the
damper assembly left protruding part, then pry out the damper assembly.
• To avoid residual ink leakage, place the removed damper on a rag.
AP-74109 Rev 1.1
表 4-72
No.
4-64
ValueJet 1304 Service manual
Part name
1 Ink tube
2 Damper fixing material