MUTOH ValueJet Service Manual page 114

Replacing Cutter Solenoid Assembly
(2)
1. Remove the cutter holder assembly.
2. Push the tab of the CR lock kicker with a sharp-pointed tool or a flat-head driver to remove the CR lock
kicker.
3. Remove the cutter solenoid assembly iron-core and the cutter solenoid spring.
4. While opening the cutter holder assembly upper tab, push out the cutter solenoid assembly from the cutter
holder assembly bottom with a flat-head driver, then remove it.
5. Remove the cutter solenoid terminal connector.
6. Replace the cutter solenoid assembly.
7. To reassemble the unit, reverse the removal procedure.
AP-74109 Rev 1.1
表 4-77
No.
1 Cutter solenoid assembly iron-
core
2 Cutter solenoid spring
3 Cutter solenoid assembly
4 CR lock kicker
5 CR lock kicker tab
4-68
ValueJet 1304 Service manual
Part name