Cr Return Position Adjustment Menu - MUTOH ValueJet Service Manual

ValueJet 1304 Service manual
5.7.1

CR Return Position Adjustment Menu

In this menu, you can adjust the CR return position (near end position of the carriage) on the origin side.
"CR Return: Check" moves the carriage three times..
"CR Return: Input" adjusts the return position of the carriage.
[>] key
[>] key
[<] key
Confirms CR return position
[<] key
Adjusts CR return position
Press [Setting/value +] or [Setting/value -]
to change the setting value.
(Range: -1.0 - 1.0mm, 0.1mm increment)
5-25 AP-74109 Rev 1.1