Head Height Adjustment - MUTOH ValueJet VJ-1638UH Operation Manual

4 Handling the printer
4.2.6

Head height adjustment

Printing with high printing rate or using strongly-curved media can cause print heads to rub.
Adjusting the distance from the print head surface to media (head height) may allow you to avoid head
rub.
Follow the procedure below to adjust the head height.
NOTE
If the head height is raised, high print quality is not guaranteed.
1. Display the Media Thickness Adjust menu on the operation panel.
a. Press the [Menu] key on the operation panel.
• "Menu1: Sleep Mode>" is displayed on the operation panel.
• The operation panel shifts to the Setup menu display.
b. Press the [>] key on the operation panel.
• "Set1: Side Margin" is displayed on the operation panel.
c. Press the [Enter] key on the operation panel.
• "User: Type 1" is displayed on the operation panel.
d. Press the [+] key or [–] key on the operation panel to select the media type to use.
• Selected User type (Type 1 to 15) is displayed.
e. Press the [Enter] key on the operation panel.
• "**>1: Print Mode" is displayed on the operation panel.
TIP
• The selected media (Type 1 to 15) is displayed in "**".
5.2 User Type menu
• If you set the User type different from the previous time when the Media detection is set to On, "Change Media
Thickness?" is displayed on Operation panel.
• Press the [Enter] key to overwrite the detected media thickness with the User type you have set here.
• Press the [Cancel] key to return to the selection screen of User type.
f. Press the [+] key or [–] key to select "**>6: Thickness Ajst.".
196
VJ-1638UH OPERATION MANUAL
4.2 Media