MUTOH ValueJet Service Manual page 279

ValueJet 1304 Service manual
NOTE
If there is no backup parameter is saved for some reason, such as parameter backup malfunction
because MAIN board is damaged, etc., install the latest firmware, initialize NVRAM, then set
parameters manually.
"6.3.2 Counter Initialization Menu" p.6-6
"5.11.2 Parameter Update Menu" p.5-56
7. Turn the printer off.
8. Slide DIP SW 2 (SW3) to right (opposite of origin side).
NOTE
After installation, make sure to set DIP SW position to the right (opposite of origin side) as shown
below.
9. Attach covers.
7-23 AP-74109 Rev 1.1