MUTOH ValueJet Service Manual page 274

(8) Starting Board Manager Mode
1. When the printer is in the operation status or in
the menu display status, press [Power] key to
turn the printer off.
2. While holding down [<] key in the operation
panel, press [Power] key.
The LCD displays [Board Manager Mode]. If [<]
key is released, the display turns to "Waiting for
command".
NOTE
If "waiting for command" is not displayed, follow the steps below.
If IP address that is not default is displayed on the board, releasing [Back] key will display
[IP192.168.xxx.xxx] (depending on the set address) on the LCD. In this case, display either of the
default IP (IP 192.168.1.253) or the set IP address using [+] and [-] key, and press [Enter] key.
Then, "waiting for command" will be displayed.
AP-74109 Rev 1.1
ValueJet 1304 Service manual
7-18