Mfp Stapler Assembly Sensor (Deflector Hp) Removal - Lexmark X651de Service Manual

7462
3. Using needlenose pliers, carefully grip the sensor and pull it out and disconnect the harness.
Replacement Notes: Using needlenose pliers, place the rear most tab in the sensor bracket first. Then push
on the rear face of the sensor until the other two tabs snap into place.

MFP stapler assembly sensor (deflector HP) removal

1. Remove the left cover. See
2. Disconnect the harness to the sensor (deflector HP).
Service Manual
4-216
"MFP stapler assembly left cover removal" on page 4-197.
Previous
Next
Go Back