Hcit Drawer Slide Assembly Removal; Hcit Elevator Motor With Sensor Removal - Lexmark C734 Service Manual

HCIT drawer slide assembly removal

The left and right drawer slide assemblies are the same, and only one is in a package. The instructions below
are for removing the left slide, but removing the right slide is similar.
1.
Remove the HCIT media tray assembly. See
2.
Remove the three screws (A) securing the HCIT drawer slide to the side frame.
3.
Remove the HCIT drawer slide.

HCIT elevator motor with sensor removal

1.
Remove the HCIT right cover. See
2.
Disconnect the connector (A) from the HCIT controller board.
"HCIT media tray assembly removal" on page
A
"HCIT right cover removal" on page
A
4-164.
4-167.
4-171
Repair information
5026