Erasing All Certificates From The Touch Panel - AMX MVP-9000i Operation And Reference Manual

Appendix B: Wireless Technology
This application must be run from a local machine and should not be used from a
remote network location.
12.
Select the target devices to be uploaded with the selected certificate. These may be:


13.
When ready to send the certificate file to the selected panels, click the Send button to initiate the upload.
Once the Status field for each entry reads Done, the upload was successfully completed.
The AMX Certificate Upload Utility is intended to be used for only one certificate at a time on the touch panel, and has
no indicator that a certification has been loaded onto a touch panel. After a certification has been loaded onto a panel
using the Certificate Upload Utility, you should immediately enter the certificate name (including file extension) into the
Client Certificate field for the specified SSID. (For more information on the Client Certificate field in the Enterprise
Mode popup window, please refer to the Security Modes section on page 68.) Make sure to double-check that the
Security Type is correct.

Erasing All Certificates From the Touch Panel

Individual certificates may not be removed from the touch panel. However, all certificates may be removed from the
device by using the erase cert telnet command, Certificates may then be re-uploaded, using the AMX Certificate Upload
Utility as needed.
182
individually selected by toggling the box next to the Send entry (with the Type column).
selected as a group by clicking on the Check All radio box located at the top of the device IP Address listing.
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom