AMX MVP-9000i Operation And Reference Manual page 45

To access the Wireless Site Survey page:
1.
From the System Settings page, touch the WiFi tab.
2.
At the bottom of the page, press the Next button to move to the second WiFi tab page.
3.
Press the Site Survey button. This action launches the Wireless Site Survey page, which displays a listing of all
detected APs in the communication range of the internal card.

The card scans its environment every four seconds and adds any new APs found to the list. Every scan cycle
updates the signal strength fields.

Access points are tracked by MAC Address.



4.
Sort the information provided on this page by pressing on a column name. This moves the sorting arrow to that
column, where it may be toggled up or down.

Up arrow - indicates that the information is being sorted in an ascending order.

Down arrow - indicates that the information is being sorted in a descending order.
If the panel detects more than 10 APs, the Up/Down arrows at the far right side of the
page become active (blue) and allow the user to scroll through the list of entries.
5.
Select a desired Access Point by touching the corresponding row. The up arrow and down arrow will be grayed out
if ten or fewer access points are detected. If more are detected, then they will be enabled as appropriate so that the
user can scroll through the list.
6.
With the desired AP selected and highlighted, click the Connect button to be directed to the selected security
mode's popup window with the SSID field filled in. From there, either Cancel the operation or fill in any necessary
information fields and then click Save.
Selecting an Open, WEP, or WPA-PSK Access Point and then clicking Connect will open the corresponding
Simple Mode popup window (FIG. 28). For any other security mode, clicking Connect will open the Enterprise
Mode popup window (FIG. 29). Different EAP methods are selectable from the Security Type button.
FIG. 28 Wireless Security: Simple Mode popup window
FIG. 29 Wireless Security: Enterprise Mode popup window
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
If the AP's SSID is set as a blank, then N/A is displayed within the SSID field.
If the AP's SSID is not broadcast, it will not show up on the Wireless Networks screen.
If an AP is displayed in the list is not detected for 10 scans in a row, it is then removed from the screen. In
this way, a user can walk around a building and track access points as they move in and out of range.
Configuring Communication
31