Installing The Mvp-Wds-9; Installing The Wall Docking Station And Plastic Back Box - AMX MVP-9000i Operation And Reference Manual

Accessories
During any installation, a lack of ventilation may produce conditions that may adversely affect the device's operation. In
these circumstances, special care must be made to make sure that temperatures within enclosed areas do not exceed the
device's maximum rated temperature.
While the outside temperature of the device may be at or below its maximum
operating temperature, special care must be taken before and during installation to
ensure that the maximum operating temperature is not exceeded within wall or rack
installation spaces.

Installing the MVP-WDS-9

Since the Wall Docking Station is intended to be affixed to a wall or other permanent structure, care must be taken to
ensure its proper installation to prevent potential damage to the MVP-9000i placed within.
Other than wall installation tools, the only tool required for this installation is a #2
Phillips screwdriver.

Installing the Wall Docking Station and Plastic Back Box

The Plastic Back Box has two pairs of knockouts at the top of the box and four (4) lockdown wings attached to the box
with Phillips-head screws. For ease of installation, the interior of the box contains an "UP" arrow pointing to the
knockouts.
The optional CB-MVP-WDS9 Metal Rough-In Box is not required for installation of
the supplied Plastic Back Box, but it offers an extra level of support.
To install the Plastic Back Box:
1.
Cut a hole into the wall or surface intended to hold the back box. The back box is sized 12 1/16 inches (30.64 cm)
long and 8 11/16 inches (22.07 cm) high, so the hole should be at least 1/4" (6.4mm) smaller in each dimension
(FIG. 15). Use the included MVP-WDS-9 Wall Docking Station template (68-5967-01) as an aid for hole
placement and measurement.
8.69"
5.56"
(22.07 cm)
(141.29mm)
FIG. 15 Recommended cutout for the MVP-WDS-9 plastic back box
18
12.06"
8.25"
(30.64 cm)
(212.7mm
12.06"
8.25"
(30.64 cm)
(212 7mm)
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
8.69"
5.56"
(22.07 cm)
(141.29mm)