Installing The Optional Metal Rough-In Box; Pre-Wall Installation Of The Cb-Mvp-Wds9 - AMX MVP-9000i Operation And Reference Manual

Accessories
8.
Firmly seat the device against the back box. Make sure that the tab connector at the bottom of the device is locked
into the back box.
9.
Insert the two installation screws from the MVP-WDS-9 Installation Kit into the screw holes in the interior
compartment of the device and tighten them to anchor the device to the back box.
For ease of installation, put each screw on a neodymium magnet in the device's
interior compartment to keep them on hand until they are needed.
10.
After fully seating the screws, wipe down the area around the screw holes with the alcohol prep pad from the
Installation Kit. Take a rubber foot and remove its adhesive backing. Put the foot, adhesive-side down, in the slot
surrounding the screw hole in the Wall Docking Station. Press down firmly to remove any air bubbles from
underneath the foot.
11.
Install an MVP-9000i device by placing it into the interior compartment bottom-first. Press the top of the touch
panel until it is flush with the Wall Docking Station. The neodymium magnets will hold it in place.
12.
To remove the MVP-9000i, unlock the touch panel (see the Unlocking the Touch Panel section on page 15 for more
information) and wait for the touch panel to pull away from the Wall Docking Station. Once it has been released,
grip it by the top of the device, and pull it free from the Docking Station.

Installing the Optional Metal Rough-In Box

The optional metal rough-in box (FG038-13) is 11.97 inches (30.40cm) wide at its widest dimension (wider than the
bezel of the Wall Docking Station), and is only intended for pre-construction installations (FIG. 17). The Metal Rough-
In Box is used in conjunction with the Wall Docking Station's plastic back box.
In order to guarantee a stable installation of the MVP-WDS-9, the distance between
the CB-MVP-WDS9 and the outer wall surface must be a minimum of .50 inches
(1.27cm) and a maximum of .1.50 inches (3.81cm).
.
Front Cover
Mounting Screws
FIG. 17 CB-MVP-WDS9 Rough-In Box - with front cover

Pre-Wall Installation of the CB-MVP-WDS9

1.
Remove the rough-in box cover (A in FIG. 17) before installation of the Rough-In Box (B).
The cover MUST be removed before drywall installation. The cover may be
reinstalled after drywall installation using 4-40 screws (not included).
20
Screws for
Dry Wall Clips
A
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
Dry Wall Clips
B