Reverting The Mvp-9000I To Factory Default Firmware - AMX MVP-9000i Operation And Reference Manual

Reverting the MVP-9000i to Factory Default Firmware

In certain circumstances, it may be necessary to return the MVP-9000i to its original factory firmware and settings. To do
so, the procedure may be started either from the touch screen during rebooting, or by accessing the Protected Setup
pages.
To revert the MVP-9000i to factory default settings via a reboot:
1.
Reboot the device, either from the Setup page (page 43) or via the Reset button on the left side of the device
(FIG. 2). Touch and hold the touch panel while the device is rebooting, until the "Request for Factory Reset"
confirmation screen (FIG. 116) appears. The Status LED on the right front of the device (FIG. 1) will also change
color from blue to red.
FIG. 116 "Request for factory reset detected" confirmation screen
2.
Release the touch screen to start the factory reset. The factory reset confirmation screen appears, warning that
continuing with the reset will result in a loss of data (FIG. 117), and the red Status LED will blink on and off. Press
Yes within 10 seconds to continue with the factory reset, or No to continue the reboot with the current settings and
firmware.
If neither button is pressed within 10 seconds, the Status LED will change back from
red to blue and the reboot will continue.
Returning the MVP-9000i to its factory defaults will remove all previous configuration
settings and user pages.
FIG. 117 Factory reset confirmation screen
3.
The MVP-9000i will now reload its factory default settings and firmware and then reboot.
To revert the MVP-9000i to factory default settings via the Protected Setup pages:
1.
From the Protected Setup page, press the Options button to open the System & Panel Options page (page 60).
2.
In the System Options section, press the Install Firmware button.
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
Upgrading Firmware
101