Powering The Mvp-Tds-9 - AMX MVP-9000i Operation And Reference Manual

Accessories

Powering the MVP-TDS-9

The MVP-TDS-9 uses the PS-POE-AT High-Power PoE Injector (FG423-81) to provide direct power for the MVP panel
via a standard Ethernet connection, both for standard function and for charging its internal battery. This also allows a
wired Ethernet connection for the panel, and the panel may be used normally while docked in the MVP-TDS-9 without
the need for a wireless connection.
Use only the RJ45 plug on the included Ethernet cable with the MVP-TDS-9. Other
RJ45 plugs will not fit in the device's jack, and attempting to use another plug may
damage the jack. If necessary, the cable may be spliced and shortened for special
installations.
For both Ethernet connection and for power for the MVP-9000i, the MVP-TDS-9 uses a special Ethernet cable (FIG. 8)
in order to connect to the PS-POE-AT.
FIG. 8 MVP-TDS-9 cable
To connect the MVP-TDS-9 to the PS-POE-AT via the special Ethernet cable:
1.
Connect the terminal end of the cable to the PWR connector on the bottom of the MVP-TDS-9.
2.
To prevent wear on the power supply cord and assure that the device's base is in full contact with the table surface,
press the cord into the locking groove running across the bottom of the device (FIG. 9).
3.
The other end of the included Ethernet cable has an input port, intended for a standard RJ45 jack. Use a standard
Ethernet cable to connect the Ethernet/PoE port to the PS-POE-AT plugging the other end of the Ethernet cable into
the Data & Power Out RJ45 port on the PS-POE-AT. Make sure that the PS-POE-AT's power cable is connected to
the device and to an available power source, and that the incoming Ethernet cable accessing the Data In RJ45 jack is
connected to the desired network.
4.
Place the touch panel in the Docking Station cradle, guiding it into place with the locking grooves on each side of
the cradle (FIG. 9). When fully seated, the touch panel's Docking Station connector should be in contact with the
Docking Station's charger pins.
12
To input port on
the MVP-TDS-9
To Ethernet cable connected
to PS-POE-AT
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom