AMX MVP-9000i Operation And Reference Manual page 182

Battery Life and Replacement
2.
Make sure to seat fully the battery plug to the connector in the device (FIG. 124). If fingers cannot be used, use a
clean, nonconductive stick or probe to seat the connectors.
3.
Reattach the back of the device, engaging the ledge at the bottom of the device and using it to swing the back down
into place.
When reassembling the device, take especial care not to pinch or squeeze the
connector wiring or the battery. Do not force the back cover onto the device, as this
can damage the device.
4.
Insert the seven screws and replace the rubber feet atop the two upper screws, using the replacement rubber feet
included in the Battery Pack Kit. Replace the bottom label over the three bottom screws, using the replacement label
included in the Battery Pack Kit (FIG. 125).
FIG. 125 Rear of the MVP-9000i-WH
5.
Slide the IR emitter cover back into place over the emitter until it clicks.
6.
Restart the device to confirm that the new battery is functioning correctly.
Please dispose of the old battery in a proper fashion as required by municipal or
federal regulations.
168
Rubber feet
IR Emitter Cover
Position of replacement label
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom