AMX MVP-9000i Operation And Reference Manual page 99

Passwords Page (Cont.)
User Access:
Enable/Enabled:
Report:
To change a previously established password:
1.
In the Password Settings page, press the button in the In Panel Password Change section for the particular password
to be changed.
Password 5 is protected, and can only be changed by the Administrator.
2.
In the Password keyboard, enter the new alphanumeric password.
3.
Press Done when complete.
Only one of the main passwords may be used to access the Protected Settings page.
An individual user password may not be used to access the Protected Settings page
unless it matches one of the main passwords.
To list a new user within the User Access section:
1.
Press a blank button in the User Access section.
2.
In the Name keyboard, enter the user's name or nickname and press Done when finished.
3.
In the Password keyboard, enter the selected alphanumeric password and press Done when finished.
4.
The new user's name will appear in the left column of User Access section. The password will also appear in the
right column, but its characters will be replaced with asterisks.
No matter how many characters are in an actual password, the Password column in
the User Access section will always show five asterisks.
To change a User Access password:
1.
Press the button corresponding to the user's name in the User Access section.
2.
In the Password keyboard, enter the user's password and press Done.
3.
Press the password button in the right column of the User Access section.
4.
Enter the new password into the Password keyboard and press Done.
To send undocking reports to the Master:
1.
From the Password Settings page, press the Report button to enable it. The MVP-9000i will send a report to the
Master of undockings in the form of an "undock-<user>" string.
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
Use these buttons to access and modify the user name/password combinations
required for removing the panel from a docking station. The number of user
access passwords on the panel is limited only by the amount of storage
memory available.
Use the UP/DN buttons to scroll through the list of saved User Access user
names and passwords.
NOTE: Enabling User Access disables and greys out the Table Dock Latch
option on the System & Panel Options page (page 60).
The Enable button allows you to toggle between activating or deactivating the
MVP panel requirement of a user to enter a pre-defined password before
removing the panel from a connected docking station:
• Off - does not prompt the user for a password, the docking station just
releases the panel when the security release pushbutton is pressed.
• On - requires that a valid password from the User Access list be entered
before removing a panel from a docking station.
The Report button enables/disables reporting the panel's docking status to the
Master.
Protected Setup Pages
85