Other Mvp-Wds-9 Installations - AMX MVP-9000i Operation And Reference Manual

2.
Fasten the CB-MVP-WDS9 rough-in box to the stud through the holes on the Stud Mounting Tabs, using either
nails or screws (not provided).
Ensure that the metal rough-in box is flush with the 2x4 studs. Any overhang will
affect the installation of the covering sheetrock, as well as affect the placement of the
Plastic Back Box.
3.
Remove the appropriate wiring knockouts from the rough-in box to accommodate the cables being threaded
through to the MVP-WDS-9.
Make sure that the power cable has been pulled through the metal rough-in box by
the resident electrician before continuing the installation.
4.
Thread the incoming Ethernet and USB wiring through the knockouts. Using the left wiring knockouts for USB
connector cables and the right wiring knockouts for the LAN/PoE In cable is very highly recommended with this
installation. Leave enough slack in the wiring to accommodate installation of the docking station.
5.
Install the drywall/sheetrock before inserting the back box for the CB-MVP-WDS9.
6.
Cut out the opening for the MVP-WDS-9 where the wall has been placed over the Rough-In Box. Cutting out the
surface slightly smaller than what is outlined in the installation drawings, so that you can make any necessary cutout
adjustments, is very highly recommended.

Other MVP-WDS-9 installations

The Wall-Mounted Docking Station is designed to be installed in various different locations, such as into the face of a
wooden podium or the top of a table. Depending upon the ability to wire it to a power source, Wall-Mounted Docking
Stations may be installed on vertical or horizontal surfaces composed of such materials as wood, brick, and glass.
Installing a Wall-Mounted Docking Station into a solid wall thicker than a standard thickness of sheetrock is possible,
but requires special preparation. If installing into a solid wall of concrete or rock, a recess must be chiselled or cut out to
match the size of the device. The box is sized 8.375 inches (21.27cm) long and 5.75 inches (14.60cm) high, so the hole
should be at least 1/4" (0.64cm) smaller in these dimensions. To facilitate the full range of movement of the device's
components, the recess must be at least 2.69 inches (6.83cm) deep.
Ensure that the power cable has been installed in the wall and is accessible by the
installer before chiseling out the recess.
Instead of using the lockdown wings to secure the Plastic Back Box, standard
concrete screws may be inserted through the screw holes after removing the
lockdown wings.
However, drill the concrete screw holes into the wall before setting the screws into the
box, as excessive torque applied to the screws will damage the box.
To avoid this, the box may be installed with adhesive. Test an unobtrusive spot on the
back of the box with a sample of the adhesive to check for any adverse reactions
before installing the device.
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
Accessories
21