Possible Spring Locations; Tools Needed - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

Possible Spring Locations

4

Tools Needed

Power Drill
Phillips Head
Screwdriver
Flat Tip
Screwdriver
Tape Measure
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
III
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Pre-Installation Inspection
3
2 1
Ratchet Wrench Pliers/Wire Cutters
7/16" Socket
1/2" Socket 7/16" Socket Driver
Safety Glasses
Note: If your Torsion Spring does not match one of the
following Torsion Springs you may not install this idrive.
4
NOTE: Option 4 depicts an EZ-Set™ torsion spring system. EZ-Set™
torsion spring system is a registered trademark of Clopay
Products - a Griffon Company.
NOTE: When installing torsion iDrive
system, there must be at least 30-3/8" of clear torsion tube between
center bearing bracket and left side of the right hand torsion spring.
3/8" Wrench
Pencil 7/16" Wrench
1/2" Wrench
Needle Nose Pliers
1
2
3
4
30-3/8"
on EZ-Set™ torsion spring
®
3/32" Drill Bit 3/16" Drill Bit
1/8" Drill Bit 5/64" Drill Bit
Step Ladder
Building
®