Positioning Opener; Positioning Mounting Bracket - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

5
Lift the Opener slightly and slide the
Tools Needed:
Right Hand Gear Assembly over so the
3/8" Wrench
Right Hand Drive Gear meshes with and
rests on the teeth of the Right Hand Gear
Assembly. Position Gear Assembly so it is
1/8" from the Opener. Hand tighten
Square Head Bolt.
Repeat for Left Hand Gear Assembly. Left
Hand Gear Assembly Square Head Bolt
should be hand tightened, then with a
wrench tighten 1 to 1 - 1/4 turns to
secure Gear Assembly. Do not tighten
Right Hand Gear Assembly at this time.
NOTE: Black Drive Gears are factory
preset. Do not attempt to turn these
gears.
6

Positioning Mounting Bracket

WARNING
Tools Needed:
1/2" Socket
LOOSENING OR REMOVING ANY LAG
Ratchet Wrench
SCREWS, OR OTHER FASTENERS FROM
THE CENTER SPRING BRACKET
ASSEMBLY COULD RESULT IN SEVERE
OR FATAL INJURY
WARNING
DO NOT MAKE ANY ADJUSTMENTS TO
THE TORSION SPRING OR ANY OF ITS
COMPONENTS BECAUSE THEY ARE
UNDER EXTREME SPRING TENSION AT
ALL TIMES.
Adjust the Mounting Bracket so it fits flush
on the header. Tighten the 5/16-18 nuts
on the threaded studs located on the
bottom of the opener.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
3
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need

Positioning Opener

1/8"
5/16-18 Nuts
Mounting Bracket
Square
Head Bolt
Right Hand
Right Hand
Drive Gear
Gear Assembly
Mounting Surface