Programming Wall Station - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

28
Tools Needed:
TO AVOID POSSIBLE SEVERE OR FATAL
None
INJURY, MANUALLY DISCONNECT THE
OPENER, USING THE EMERGENCY
HANDLE PRIOR TO PROGRAMMING
REMOTE CONTROLS.
THE OPENER SHOULD ONLY BE
DISCONNECTED WHEN THE DOOR IS IN
THE CLOSED (DOWN) POSITION.
OTHERWISE, IN CASE OF WEAK OR
BROKEN SPRING(S), THE DOOR COULD
FALL, CAUSING SEVERE OR FATAL
INJURY.
a. Pull the emergency Disconnect Handle
b. On the front cover of the Opener, press
c. Press and hold the Wall Station light
No beeping response from the Opener
during the Wall Station programming
indicates a programming failure. Repeat
programming Steps a-c.
d. Return the Emergency Disconnect
Note: The opener can be activated by up
to six remote control devices (including
Wall Station, Transmitter, and Keyless
Entry Devices). If a seventh control is
programmed, the first of the program
controls will be overridden and will no
longer activate the opener.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
17
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need

Programming Wall Station

WARNING
WARNING
to the manual door operated position
(lower position).
and release the Red Program Button;
the Opener will beep once, indicating
activation of the program mode. The
Opener will remain in Program Mode
for 30 seconds. If at the end of 30
seconds the Opener has not learned an
RF device, the Opener will beep once;
indicating the learn mode is no longer
active.
button until the Opener beeps once.
The Wall Station is now programmed.
Handle to the Motor Operated position
(upper position).
Handle In Manual
Door Operated
Position
a
b
c
LEDs
Red Program
Button
Motor in
Up Position
d
Light Button
Handle In Motor
Operated Position