Aligning The Safety Sensors; Install Standard Upper Limit Routine - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

31

Aligning the Safety Sensors

Align the Safety Sensors by moving the
Tools Needed:
Sending and Receiving Units in or out until
7/16" Wrench
the Alignment Light on the Receiving Unit
comes on. The 1/4-20 Carriage Bolt can be
loosened to move the Safety Sensor in or
out, as required. If you have difficulty
aligning the beams, check that both
Mounting Brackets are mounted at the
same height and remount if necessary.
Additional minor adjustments can be made
by slightly bending the Mounting Brackets.
Once the Alignment Light comes on, tighten
all bolts and mounting screws. Finish
securing all wire making sure not to break
or open any of the conductors. Loop and
secure any excess wire.
32
Install Standard Upper
WARNING
Tools Needed:
None
TO AVOID INJURY, NO ONE SHOULD CROSS
THE PATH OF A MOVING DOOR!
NOTE: The door must be in its fully closed
position and the disconnect handle must be
in the motor operated position (upper
position) to initiate the install routine.
NOTE: Install routine will not run if safety
sensors are not aligned.
Press and hold the profile button for five
(5) seconds. The opener will beep twice,
indicating the activation of the install routine.
The door will now move to the fully open
position and stop, beep twice and then the
door will close completely.
Next, the door will go through one more up/
down cycle. Once this is complete, the door
limits are set and the installation is complete.
NOTE: Upon successful completion of Step
32, proceed to Step 34.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Please Do Not Return This Product To The Store Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Limit Routine
Top View
In
Out
1/4-20 Carriage Bolts
For this adjustment, bend mounting brackets
at wall mount
Top View
In
Out
Profile Button
20