Preparing For Installation; Installing Gear Assemblies; Tools Needed - Wayne-Dalton IDrive 3651-372 Installation Instructions And Owner's Manual

1

Preparing for Installation

a. If the header does not provide a

Tools Needed:

Tools Needed:
mounting surface for the Opener, a
None
proper mounting surface will need to
be installed.
Securely fasten a wood mounting
surface (2" X 6" recommended) to the
building structure. Make sure the
surface is flush with the header and
properly positioned to allow mounting
the Opener on it.
b. Position Mounting Bracket over
threaded studs and hand tighten with
the (2) 5/16" X 18 hex nuts and
(2) lock washers.
NOTE: Black Drive Gears are factory set.
Do not attempt to turn these gears.
2

Installing Gear Assemblies

Tools Needed: Tools Needed: Tools Needed:
Clean torsion tube of dirt and loose rust
prior to installing the Gear Assemblies.
3/8" Wrench
Remove the Bridge Gears from the
Gear Assemblies.
Place the main gear onto the Torsion
Tube. Orient the Bridge Gear so it can
slide into position surrounding the torsion
tube. Ensure both pieces fit together
properly.
Secure the Bridge Gear to the Main Gear
with the (2) 1/4-20 x 3/8" screws.
Repeat procedure with second Gear
Assembly. Slide the Gear Assemblies
19" apart. See illustration for proper
orientation of the Gear Assemblies.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
1
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
a
b
Studs
Mounting
Bracket
Gear Assembly
Torsion
Tube
Mounting Surface
(2' x 6" Recommended)
Opener
Lock Washers
5/16" -18 Nuts
Main Gear
Bridge
Gear
1/4-20 x 3/8"
Screws
Black Drive
Gears